This yard publishes a material takeoff, where you can enter footage, type, height, spacing, and gate count. The notes below explain the arithmetic and the field measurements that go into a material list.
Measure the run, then subtract the openings
Walk the line with a tape or a wheel and write down each straight segment, including the sides of a corner. Do not measure only the street frontage if the job turns down the property line. Record the above-grade height you want, and note grade changes, steps, retaining walls, and anything the fence has to pass, such as a meter, a clean-out, or a swale.
Gates are openings, not extra fence. A four-foot walk gate removes four feet of face from that segment; a twelve-foot farm gate removes twelve. Post counts still include the gate posts, which is why a count that only multiplies footage by a post spacing will be short at every opening. The takeoff subtracts the gate width from the net run, then adds terminal posts at each end and at each gate.
Post spacing and why it matters
Once you have a net run, the line-post spacing decides how many bays you have. A common planning figure is eight feet on wood and vinyl privacy, ten feet on residential chain link, six feet on many aluminum panels, and twelve feet on woven field fence. A heavy cap, a high-wind exposure, a short rail, or a written specification can tighten the spacing, and a farm run can be wider if the wire and the braces are designed for it.
A straight run of 150 feet of wood privacy at eight-foot spacing, after a four-foot walk-gate opening, has a net run of 146 feet. That is 19 sections if you divide and round up, with line posts between the terminals and four end or gate posts. Change the spacing, and the post and rail counts move with it. That is also why the takeoff lets you edit footage and gate count and recalc.
Face material follows the style
Wood privacy picket counts come from the net run and the actual face width of the board, often about 5.5 inches on a nominal 1x6, with almost no gap on a tight privacy face. Shadowbox and board-on-board use more boards because of the second face or the overlap. Rails are counted by the number of sections times the number of rails high — three rails is common on a six-foot privacy face.
Chain-link fabric, top rail, and tension wire are counted as the net run length at the height you select. Vinyl privacy is often counted in eight-foot sections on 5x5 posts. Aluminum is often counted in six-foot panels. Woven field fence is often counted in 330-foot rolls, a common agricultural roll length, which is why a quarter mile of pasture fence is often about four rolls, plus leftover that you should not pretend is exact.
Concrete, frost, and the limits of a planning count
Concrete in our tools is shown at two bags per post as a starting point. Hole diameter, depth, and bag weight change the number, and T-posts on a farm run are often driven rather than set in concrete. A common reminder for post depth is about one-third of the above-grade height, and not less than the local frost depth. Confirm frost depth with the local building department.
Do not use a straight-run count when the job has a lot of corners, a steep grade, racked vinyl, stepped aluminum, a slide gate, or a mixed-height elevation. Those jobs need a takeoff from a plan or a careful field sketch. Send us the plan. The takeoff is there to get a simple job onto a quote request quickly, and to help you see the size of the material list, not to close the book on a complicated site.
Turn the list into a quote request
When the planning count looks reasonable, send it. The takeoff has a button that prefills the quote form with the material list so you can review it, edit the quantities, and add the job name, city, and contact information.
If you are standing in the yard with a sketch on the hood of a truck, the same method applies: measure, subtract openings, pick a spacing, count terminals separately, and say where the assumptions might be wrong. We would rather price a slightly conservative list with honest notes than an optimistic one that runs short on the last bay.
